On this page
To analyse a bank, separate its ability to absorb losses from its ability to meet payments when they fall due. Regulatory capital is a loss-absorption measure; liquidity and stable funding address cash timing and the durability of liabilities. A good CFA® Level II answer explains which risk a figure tests before deciding what the figure means.
Why an ordinary company template misleads
A manufacturer makes goods with plant, inventory and receivables. A deposit-taking bank makes loans and holds securities, then finances much of that asset book with deposits and other obligations. Its productive assets are financial claims whose value and cash flows can shift with borrower credit, interest rates and market conditions. Its liabilities may also be repayable long before its loans mature. That combination makes a strong-looking accounting profit an incomplete answer to whether the institution can withstand a shock. The CFA Institute reading on financial institutions puts regulation and systemic risk at the centre of the subject, and identifies banks and insurers as the main institutions under analysis.
The distinction is about the economic balance sheet as well as the published one. A bank's loan may be recorded at an amount that does not immediately reveal worsening collectability. A security may be readily saleable in a calm market but much less helpful during a funding stress. A customer deposit is a liability, yet it is also a source of financing that can be withdrawn. Candidates should ask what the line item does under pressure, not merely whether it appears on the asset or liability side. Exposure concentration, maturity, currency and the reliability of funding matter alongside reported earnings.
The three questions behind the framework
Start with capital: after losses, is enough eligible capital left relative to the risks carried? The Basel Committee's risk-based capital standard expresses its minimums against risk-weighted assets. Common Equity Tier 1 is the most direct cushion in this comparison; Tier 1 adds eligible additional instruments, while total capital also includes eligible Tier 2 instruments. The standard gives minimum ratios of 4.5% for Common Equity Tier 1, 6% for Tier 1 and 8% for total capital. It separately specifies a 2.5% capital conservation buffer in Common Equity Tier 1, and notes possible additional buffers. These are Basel framework figures, not a claim that every jurisdiction applies an identical requirement to every bank.
Next ask about immediate liquidity. A bank may own assets with value on paper while lacking cash it can produce fast enough to honour outflows. The Basel Committee's liquidity coverage ratio standard compares eligible high-quality liquid assets with net cash outflows under a prescribed 30-calendar-day stress. The standard normally requires a ratio of at least 100%, while expressly allowing use of the buffer in stress with a supervisory response shaped by circumstances. The wording matters: liquidity is meant to be usable, so a stressed decline below the normal threshold is not automatically the same conclusion as a routine breach in ordinary conditions.
Finally ask whether the bank has dependable funding for the assets it intends to carry. The Basel Committee's net stable funding ratio standard compares available stable funding with required stable funding. It addresses a longer structural mismatch that a short cash survival test cannot settle. A bank could pass the short stress calculation because it has enough immediately saleable assets, yet still rely heavily on liabilities that require repeated refinancing. The reverse can also occur: a stable financing profile does not prove that cash is available in the right place and currency tomorrow.
An illustrative balance sheet decision
Consider an invented bank, with all amounts in the same illustrative currency units. It has risk-weighted assets of 100, eligible Common Equity Tier 1 of 6, eligible Additional Tier 1 of 1, and eligible Tier 2 of 2. Its Common Equity Tier 1 ratio is 6 divided by 100, or 6%. Tier 1 is 7 divided by 100, or 7%, and total capital is 9 divided by 100, or 9%. Against the Basel Committee minimums just cited, all three clear their simple minimums. But the 6% Common Equity Tier 1 figure is below 7%, the sum of the baseline 4.5% minimum and the 2.5% conservation buffer. The correct interpretation is therefore not a blanket statement that the bank fully clears every Basel capital condition. Buffer treatment and any additional local requirements need separate consideration.
Now give the same invented bank 24 of eligible high-quality liquid assets and 20 of prescribed net cash outflows over the stress horizon. Its illustrative liquidity coverage ratio is 24 divided by 20, or 120%. It passes the normal Basel ratio in this simplified calculation. This does not repair the capital-buffer issue: cash availability and loss absorption are different questions. It also does not show where the liquid assets sit within a banking group. The Basel standard discusses limits on moving liquidity across entities and currencies. An analyst would look for those restrictions before treating a group-wide ratio as proof that every subsidiary can meet its own cash needs.
Suppose available stable funding is 80 and required stable funding is 100. The invented net stable funding ratio is 80%, below the Basel framework's 100% minimum for that measure. The bank can therefore be adequate on its short stress calculation while weak on structural funding. No single figure is a complete safety verdict. What the example teaches is to preserve the numerator, denominator and time horizon of each test. If a question changes the funding mix without changing current cash, the stable funding result may move even when the immediate liquidity result does not.
What to investigate after the ratios
Move from a calculation to a diagnosis. Check credit quality: are loan losses, arrears or concentrated borrowers changing the reliability of expected repayments? Check interest rate exposure: might repricing alter margins or asset values? Check earnings quality: are profits recurring or driven by items that will not replenish capital when credit costs rise? Then read disclosures for off-balance-sheet commitments and contingent calls on cash. These are prompts for analysis, not a licence to assume that any one unfavourable item makes a bank insolvent. The CFA Institute summary also points to management, market sensitivity and other contextual factors in bank analysis.
Regulation can be a floor for examination analysis, but it is not a substitute for understanding the business model. Two banks with the same ratio may differ because one has diversified borrowers and stable retail funding while the other has concentrated lending and financing that must be rolled frequently. The ratio labels stay the same; the economic resilience does not. In an exam explanation, say what extra information would discriminate between those banks. This shows that you can use the framework without pretending that the published metric predicts an outcome on its own.
Common exam traps and a compact method
The first trap is to call deposits equity because they fund loans. They are liabilities, and their behaviour affects funding and liquidity rather than turning them into loss-absorbing capital. The second is to compare capital with total assets when the stated requirement is based on risk-weighted assets. A non-risk-based leverage measure exists, but it answers a different question. The third is to treat a reported ratio above a bare minimum as proof that buffers and every supervisory condition are satisfied. State the exact threshold being tested and identify what remains unknown.
A fourth trap is to equate liquidity with profitability. A bank can be profitable in an accounting period and still have a cash timing problem; it can also have ample liquid assets while expected losses threaten capital. Read a bank question in this order: identify the risk, choose the denominator and horizon, calculate if data permit, compare with the applicable condition, and then add a short limitation. The CFA program page gives the broader course context, while the methodology page explains Omni's approach to working through such distinctions. The useful habit is to name the economic question before reaching for a percentage.
Sources
- Analysis of Financial Institutions | CFA Institute · cfainstitute.org · Retrieved
- Risk-based capital requirements | Bank for International Settlements · bis.org · Retrieved
- Liquidity Coverage Ratio | Bank for International Settlements · bis.org · Retrieved
- Net stable funding ratio | Bank for International Settlements · bis.org · Retrieved



