On this page
An FRM® candidate can set a first-pass pace from GARP’s published format: four hours for 100 equally weighted Part I questions, or four hours for 80 equally weighted Part II questions. That works out to 2.4 minutes per Part I item and 3 minutes per Part II item before allowing any review time. A useful plan spends less than that average on the first pass, marks costly questions for return, and checks progress against the remaining clock rather than trying to give every item identical attention.
The official format sets the constraint
GARP states on its FRM programme and exam page that both parts are computer-based, multiple-choice examinations with equally weighted questions. Part I has 100 questions and Part II has 80; each exam lasts four hours. Those facts support arithmetic for a time budget. They do not tell candidates that each question takes the same amount of work or that a particular pacing rule is officially recommended. The checkpoints below are an editorial planning tool to practise and adjust, not a rule issued by GARP.
Convert four hours to 240 minutes. Dividing 240 by 100 gives a Part I average of 2.4 minutes per question; dividing by 80 gives a Part II average of 3 minutes. These averages assume every minute is available for solving. The GARP exam policies state that the on-screen clock is the official timekeeper and that time does not stop during a break. A candidate who wants a review pass or expects a break must leave room for it inside the same 240 minutes.
Equal weighting makes the opportunity cost of prolonged effort visible. A difficult question is worth the same as a straightforward one under the format GARP publishes. If extra time on one item prevents several simpler items from receiving a first answer, the strategy has a cost even if the hard item is ultimately solved. This is not an instruction to skip all calculations. It is a reason to decide in advance when to move on and to practise using that decision under a timed, realistic setting.
A first pass and a return pass
One workable starting plan reserves 20 minutes at the end for marked items and a submission check. That leaves 220 minutes for a first pass. The first-pass averages become 2.2 minutes for each Part I item and 2.75 minutes for each Part II item. The 20-minute reserve is an illustrative personal choice, not a GARP requirement. Some candidates will need more review time, while others may prefer a smaller reserve after measuring their own practice pace. What matters is that the budget is chosen before a hard question consumes it by accident.
On a first pass, answer an item that can be solved confidently within its working budget. If the necessary approach is clear but the arithmetic is lengthy, make a brief note of the needed step and mark it if the platform permits. If the approach is unclear, select the best supported answer available under the exam interface and flag the item for a later attempt where possible. Confirm the marking and navigation behaviour during official practice rather than assuming every computer-based test behaves alike. GARP says only final confirmed and submitted answers are graded, so the end-of-exam submission step needs deliberate attention.
A time threshold should be a decision aid, not a stopwatch ritual. A conceptual item may need under a minute, leaving space for a multi-step calculation. If an item has already consumed much more than the first-pass average and no credible next step is visible, additional time has a high opportunity cost. Record what blocks progress, move on, and return after the rest of the paper has received attention. A candidate who repeatedly guesses the same way at a blocked item is not gaining information by rereading it without a new method.
Checkpoints from the illustrative budget
The 220-minute first-pass plan can be split into four equal work blocks of 55 minutes. For Part I, each block covers 25 questions, and for Part II each covers 20. The clock is a better checkpoint than the wall time because the official timer may start after exam-room procedures. At question 25 in Part I, or question 20 in Part II, a candidate following this illustrative plan would aim to have roughly 185 minutes left: 240 minus 55. At the halfway mark, the aim is about 130 minutes left. At the final first-pass checkpoint, 20 minutes remain.
| One quarter | 25 | 20 | 185 minutes |
| Half | 50 | 40 | 130 minutes |
| Three quarters | 75 | 60 | 75 minutes |
| Complete | 100 | 80 | 20 minutes |
These checkpoints do not imply that exactly one quarter of the exam’s difficulty appears in each quarter. They simply make a drift visible early enough to respond. If the candidate is behind at the first checkpoint, examine whether too many items were left unanswered, whether a calculation was pursued without a plan, or whether interface navigation took longer than expected. A small correction made then is more realistic than trying to recover all lost time in the last few questions.
Suppose a Part I candidate reaches question 50 with 115 minutes remaining, 15 minutes below the illustrative halfway target. The rest of the first pass contains 50 questions. If the candidate still wants 15 minutes for review, only 100 minutes remain for those 50 items: an average of 2 minutes each. The sensible response is to shorten unproductive attempts and secure a first answer across the remaining items. The figures are an invented pacing scenario, not a prediction about exam content or a claim that 2 minutes is enough for every item.
Suppose instead a Part II candidate reaches item 40 with 145 minutes remaining, 15 minutes ahead of the illustrative target. That surplus can absorb a difficult later block or strengthen the return pass. It should not be spent automatically on the next single problem. Keep the budget visible: 40 questions remain, and preserving a 20-minute review reserve leaves 125 minutes, slightly more than three minutes per remaining item. Extra time is most useful when it protects coverage of the full paper.
Practice the plan with official materials
GARP’s study materials page lists official practice exams and learning objectives. A timed practice run can test whether the first-pass target is realistic for this candidate, under the same four-hour overall constraint. Record time at each quarter checkpoint, the number of marked items, and whether the final review changed a defensible answer. The purpose of the log is diagnosis: slow formula recall, rereading, arithmetic checks or a tendency to stay too long with uncertain questions each calls for a different adjustment.
A practice question is not a promise about the live paper. GARP notes that chapter practice questions in its learning platform are not representative of actual FRM exam questions. Use the official exam-format facts for the total time and item count, and use your own timed attempts to test a workflow. A candidate who practises only untimed chapter work may know the concepts but have no evidence about navigation, first-pass speed or the time needed to confirm final answers. Those practical details belong in the rehearsal.
The content also shapes pacing. Part I spans foundations, quantitative analysis, financial markets and products, and valuation and risk models. Part II covers applied risk areas including credit, market, operational and liquidity topics as GARP lists them. A candidate may therefore encounter both rapid recognition tasks and slower multi-step reasoning. It is unhelpful to preassign a rigid number of seconds to every question type. The quarter checkpoints preserve a whole-paper budget while allowing local flexibility for the actual mix.
Exam-day boundaries
The on-screen clock governs the exam, so a personal watch should not be the basis of a timing plan. The exam policies say breaks are possible but the timer continues to run. A candidate who plans to step away should build that time into practice, then revise the first-pass target accordingly. The same policies describe final answer confirmation and submission as the graded record. Leave a clear end-of-exam margin for those actions instead of using the last available second on an uncertain item.
Before exam day, review the current GARP exam policies and the FRM programme page for the official mechanics. For a wider preparation route, the FRM® programme guide and Omni study methodology can help organise practice. The final pacing plan should be written as an operational instruction to yourself: target a first answer for every item, mark only genuine return candidates, check the clock at agreed progress points, and preserve time to submit the answers you want graded.
A successful rehearsal answers a narrower question than whether the candidate will pass: can this particular candidate cover the published number of questions within the published time while retaining a deliberate review window? If the practice evidence says no, reduce time spent on low-progress attempts, improve recall of repeatedly slow topics, or reset the review reserve and test again. The four-hour format is fixed by GARP; the allocation within it is a candidate decision that should be informed by actual timed work.
Sources
- FRM Program and Exams - GARP · garp.org · Retrieved
- FRM Exam Policies - GARP · garp.org · Retrieved
- FRM Study Materials - GARP · garp.org · Retrieved



